叉車電池安裝步驟 Crown電動叉車維修9PZS900 科朗36V牽引用鉛酸蓄電池組900Ah配件

Crown科朗叉車電瓶采用了鉛、鈣、錫、銀、鉍五元素專利配方，避免了早期容量損失和失水干涸的失效模式。貝朗斯叉車蓄電池公司提供科朗全系列電瓶叉車蓄電池配件維修服務。使活性物質和板柵合金之間結合力強，導電性強，采用極組化成、電池化成雙化成，定量注酸，內阻、電壓、容量的循檢配組等工藝，使蓄電池一致性高。成組使用浮充電壓差≤40mV，起始電壓差≤20mV，內阻差≤15%。科朗叉車電池放電后,盡早進行充電。充電時,電池的溫度會升高約10℃。蓄電池的溫度不可超過55℃,否則會降低電池的壽命。開始充電時的溫度必須低于45℃。如大于45℃,應等冷卻后再充電。禁止對電瓶過度放電，放電不要超過標準容量的80%,此時,電解液密度不低于1.13公斤/升。經常過度放電將降低電池的壽命。充電過程必須完全,不可以對電瓶斷續充電，經常斷續充電會損傷蓄電池。Crown's forklift battery uses patented formulas of five elements: lead, calcium, tin, silver, and bismuth to avoid early failure modes such as capacity loss and dehydration. Belluns Forklift Battery Co., Ltd. provides a full range of Kelang battery forklift battery parts maintenance services. Make the active material and grid alloy have strong bonding force and strong conductivity. Adopting extreme formation, battery formation, double formation, acid injection, and se inspection of internal resistance, voltage and capacity, etc. . The floating charge voltage difference is less than or equal to 40mV, the initial voltage difference is less than or equal to 20mV, and the internal resistance difference is less than or equal to 15%. When the battery of the Corum forklift is discharged, charge it as soon as possible. When charging, the temperature of the battery will rise by about 10 ° C. The temperature of the battery must not exceed 55 ° C, otherwise the battery life will be reduced. Therefore, the temperature at the beginning of charging must be lower than 45 ° C. If it is higher than 45 ℃, it should be charged after cooling down. Do not over-discharge the battery. Do not discharge more than 80% of the standard capacity. At this time, the density of the electrolyte is not less than 1.13 kg / liter. Frequent over-discharge will reduce battery life. The charging process must be complete. Do not intermittently charge the battery. Frequent intermittent charging will damage the battery.